This washer and dryer set has been around for some time now, the 3000 sequence could be nearly 12 a long time previous.

Accessing the washer’s primary components is largely carried out from the front, to get rid of the again is basic, I will describe “How To” at the conclude of this write-up.

The first step in accessing your washer is to get rid of the screws all around the doorway body. There are two screws positioned on the door hinge and two right reverse. miele kundendienst berlin will need to have to be taken out to acquire access into the inside of of the washer.

With the entrance off the washer, the drain pump, motor handle board and a number of other factors will be obvious and accessible. The motor management on the appropriate is identified for going out, if your washer stopped spinning, presents an LR error code, this motor management is the likely culprit. Cleaning the pump can be done from the front or the back again, the again panel is held restricted with four screws. The only trick to getting the back panel again on is to snap the plastic on to the steel prior to the panel is set up.

If you are 1 of the unfortunate ones working with the wax motor manage board malfunction, you are not by itself, the top of the washer will need to be lifted in get to acquire obtain.

To do so the four screws below the soap dispenser will require to be eliminated, these are the screws the arrows are pointing to in the image on leading of the washer.

In get for the prime raise cost-free the two corner brackets will require to be taken out, if you have already taken out the screws all around the door body and the front is off you will see the two brackets that keep the top down, one particular five/sixteen screw retains each bracket.

With the four screws eliminated from the soap cup housing and the two metallic clips, the leading will raise up.